Biospherical Instruments Inc.
Home
Products
Aquatic Profiling Radiometers
C-OPS
XRR Profiler
BIC and BIR
Natural Fluorometers
Laboratory Radiometers
AMOUR Radiometer
QSL Series
Single-Channel Radiometers
Q- and M-Series
AMOUR Radiometer
Microradiometers
Atmospheric Radiometers
GUV Radiometers
GUVis-3511 Radiometer
Accessories
BioSHADE
BioGPS
BioTRACKER
BioHOIST
BioMAST
Software
Profiler
µProfile
Contact Sales
Brochures
Wavelength Selection
C-PrOPS for C-OPS
Services
Calibration
Spectral Response
Radiance
Standards
Directional Response
Immersion Coefficient
Irradiance
Custom Development
Leasing
Intercomparisons
Environmental Measurements
Research
Calibration Facilities
Custom Instrumentation
UV Monitoring
Publications
Workshops and Training
Field Campaigns
COAST Campaign
2017 Solar Eclipse
UV Monitoring Network
Support
Software
Email Support
Retired Instruments
Request RMA
Terminology
FAQs
Knowledge Base
Application Notes
About BSI
Announcements
Contact Us
Representatives
Gallery
Community Involvement
You are here:
Home
All FAQs
Frequently Asked Questions
FAQs - All FAQs
How do I calculate UV-B and UV-A from GUV data?
What is the difference between the GUV-511 and GUV-2511?
Can I acquire data over the Internet?
I tried to replace the Fuji temperature controller and it is no longer available, what do I do?
What is an immersion coefficient?
Can I get a spectral response for my GUV?
What does the "integrated" column in my software contain?
In many scientific papers we’ve seen the units of the readings in W/m2. Is this the same unit as the one the software uses (i.e., W/m2/nm)? Do we need to do some calculations to obtain W/m2?
How often do we need to do the “dark correct” or “zero”? We did the “dark correct” when we measured the irradiance in our culture chamber. When we go into the field, we will do it again, but do we need to do it every time we go into the field?
We aren’t sure about the numbers that we must put in the Data Recording and Sampling Tabs, specifically in the “Largest single channel tag” and in the “Largest multichannel tag”. What should we do?